atomictrio.blogg.se - Free gear template generator download

Generator designs Module and Number of Teeth. After placement selection of the gearing geometry a preview for gearing displays in the Autodesk Inventor window. Enter Desired Gear Ratio and Center Distance values, or select Cylindrical face for both gears in an assembly on position where gearing is placed (Center Distance is measured from Autodesk Inventor assembly).In the Common area, select Module and Number of Teeth option from the Design Guide drop-down list.

Click OK to insert the gear set into the assembly.Reports of the calculation are displayed in the Summary of Messages area which is displayed after clicking the chevron in the right lower part of the Calculation tab.

The inputs that fail the calculation are displayed in red (their value does not correspond with other inserted values or calculation criteria).

Calculation results are displayed in the Results area.

Generator designs the gear set model based on entered parameters.

Click More in the right-lower corner to insert more calculation values and criteria.

Specify numbers of teeth and place the gear set in the assembly, if desired.

In the Gear 1 and Gear 2 areas, select Component, Feature or No Model from the drop-down list.

Set you desired values, such as Pressure Angle, Helix Angle, or Module.

These two options enable the most logical options to insert your gear model. According to your selected option from the drop-down menu, the options are enabled in the Design tab.

In the Common area, select Center Distance or Total Unit Correction options from the Design Guide drop-down list.

On the ribbon, click Design tab Power Transmission panel Spur Gear.